The ada requires 59 inches and 27 inches your manufacturer s instruction sheet should be consulted for recommended mounting heights.
Baby changing station mounting height ada.
Where a forward reach in unobstructed the high forward reach shall be 48 inches 1220 mm maximum and the low forward reach shall be 15 inches 380 mm minimum above the finish floor or ground.
The ada americans with disabilities act has set requirements for baby changing stations.
Install at the perfect height.
The americans with disabilities act ada was created to ensure access to buildings and structures for people with disabilities.
Ada regulations also state that baby changing stations must be located in an area that is easily accessible and free from obstructions.
Below is a diagram from diaper depot about mounting baby changing stations.
Recess mounted plastic baby changing station with stainless steel flange is a stylish and safe option for restroom facilities.
Baby changing stations types.
Knee clearance must extend 25 inches under a changing table and the unit must be 9 inches above the finish of the ground.
There are specific mounting heights and other requirements of baby changing stations in restrooms says ada compliance expert joan stein of stein consulting inc pittsburgh.
See figure s 308 2 a.
The ada standards are issued by the department of justice doj and the department of transportation dot.
Figure 308 2 a forward reach.
Horizontal stainless steel recess mounted kb110 ssre.
Oval baby changing stations.
Protruding objects units are not to protrude more than 4 inches from the wall when closed.
Toe clearance at least 9 inches 230mm above the finish floor must be provided for the full depth.
Recess mounted stainless steel clad baby changing station is the premier choice for upscale restroom facilities.
Check your local code for addition information and requirements.
The ada mandates that baby changing stations be present in both men s and women s restrooms and must be placed at a height of 27 inches from the floor.
Five tips for ada compliance.
Any change to restroom functionality inevitably turns to the question of americans with disabilities act ada compliance.
For horizontal changing stations the ada requires that the unit protrude no more than 4 from the wall and be no higher than 27 inches from the floor.
When the unit s bed is opened and laid flat it must provide adequate knee clearance below the station.
They have to be mounted so that the very top of the changing table surface when it is opened cannot be any higher than 34 inches off the floor she says.
This is required so patrons using wheelchairs can easily access the unit as well as open and close the changing station.